Specifications

Property Test method Requirement Success
Total thickness, mm CAN/CGSB 37.54-95
ASTM D751-00		 1.2 min. Success
Thickness of the film, mm
Median measure
Minimum measure		 CAN/CGSB 37.54-95
ASTM D751-00		 0.4 min.
0.32 min.		 Success
Tear resistant, kN/m
Machine direction
Sense through		 CAN/CGSB 37.54-95
ASTM D751-00		 35 min. Success

Elongation at break point, %
Machine direction
Sense through		 CAN/CGSB 37.54-95
ASTM D751-00		 15 min. Success

Resistance of a lap joint, % of breaking strength
Machine direction (initial)
Cross-Sense (initial)
Machine sense (after 7 days in boiling water)
Sense through (after 7 days in boiling water)		 CAN/CGSB 37.54-95
ASTM D751-00		 75 min.
75 min.
70 min.
70 min.		 Success

Impact of a low temperature		 CAN/CGSB 37.54-95
ASTM D1790-02		 8 à 10 min. Success

Effects of water absorption
Increase in mass, %
Resistance to fracture,% of original data
Sense through
Elongation,% of original data
Sense through		 CAN/CGSB 37.54-95
ASTM D570-98		 3.0 max.
90 min.
90 min.90 min.
90 min.		 Success
Change of dimension, %
Without charge
With load (machine direction)
With charge (Sense through)		 CAN/CGSB 37.54-95 0.5 max.
0.5 max.
0.2 max.		 Success

Penetration cone, N		 CAN/CGSB 37.54-95 30 min. Succees
Abrasion resistance ASTM D1242
Method A		 Weightloss -0.04
Depth of wear -0.025		 Success
Adherence to the substrate
Adhésif WB3612 = 354
Adhésif SC0122 = 130		 CCMC 07543 +125 Success
Anti-slip property
Dry conditions – Leather
Dry conditions – Rubber
Moist conditions – Leather
Wet conditions – Rubber		 CCMC 07543 +0.50 Success

Technical drawings

Outside Perimeter Drip Flashing / PVC Clip

Outside Perimeter Mechanical Fastener

Outside Perimeter Heat Welded PVC Flashing

Outside Perimeter Concrete Face Flashing

Outside Perimeter Curb / Ponywall

Typical Deck to Wall

Welded Seam

WDD-1 Deck Drain

Masonry Wall Detail

Pre-Installed Finishing Strip

Inverted Galvanized Edge Flashing

Stucco Cut-Out with Trim Board

Removable Trim Board

Surface Mount Post Attachment